2006 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE

System Specifications

Cylinder Head

Factory service manual diagram




1. Tighten all bolts in alphabetical sequence 40 Nm (4.1 kgf-m, 29.5 ft. lbs.)
2. Retighten all bolts in alphabetical sequence 95 Nm (9.7 kgf-m, 70.1 ft. lbs.)

Caution: If the bolt make stick-slip sound during tightening, repeat the procedure from step (1). In this case, the cylinder head gasket can be reused.

3. Loosen all the bolts in reverse order of installation 180°
4. Loosen again in the same order 180°
5. Tighten all bolts in alphabetical sequence 10 Nm (1.0 kgf-m, 7.4 ft. lbs.)
6. Retighten all bolts in alphabetical sequence 30 Nm (3.1 kgf-m, 22.1 ft. lbs.)
7. Retighten all bolts in alphabetical sequence 60 Nm (6.1 kgf-m, 44.3 ft. lbs.)
8. Retighten all bolts in alphabetical sequence 80 - 90°
9. Retighten all bolts in alphabetical sequence 40 - 45°

Caution: The tightening angle of the bolt should not exceed 45°

10. Retighten bolts (a) and (b) by 40 - 45°

Caution: Make sure the total "tightening angle" of steps (9) and (10) does not exceed 90°.

Surface warpage limit (Mating surface with cylinder block) 0.03 mm (0.001 inch)
Grinding limit 0.1 mm (0.004 inch)
Standard height 97.5 mm (3.84 inch)

Camshaft Bearing Cap

Temporarily tighten the bolts (a) through (d) in alphabetical sequence.

Factory service manual diagram




Install the valve rocker assembly.
Tighten the TORK bolts (e) through (j) in alphabetical sequence using the ST. ST 499497000 TORX PLUS
Tightening Torque 18 Nm (1.8 kgf-m, 13 ft. lbs.)

Factory service manual diagram




Tighten the bolts (k) through (r) in alphabetical sequence.
Tightening Torque 9.75 Nm (1.0 kgf-m, 7.2 ft. lbs.)

Factory service manual diagram




Tighten the bolts (s) and (t) in alphabetical sequence.
Tightening Torque 9.75 Nm (1.0 kgf-m, 7.2 ft. lbs.)

Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.