2006 Subaru Forester XT Limited, AutomaticFACTORY OEM SERVICE PROCEDURE

DTC P0604 Internal Control Module Random Access Memory (Ram) Error

DTC DETECTING CONDITION: 

TROUBLE SYMPTOM: 

  • Engine does not start.
  • Engine stalls.
CAUTION: After repairing or replacing the defective part, carry out the Clear Memory Mode <Ref. to OPERATION , CLEAR MEMORY MODE. > and Inspection Mode <Ref. to PROCEDURE , INSPECTION MODE. >

WIRING DIAGRAM: 

Fig 1: Identifying Internal Control Module Random Access Memory Error - Wiring Diagram
G05002036Courtesy of SUBARU OF AMERICA, INC.
TROUBLESHOOTING CHART

Step Check Yes No
1 CHECK ANY OTHER DTC ON DISPLAY.  Is DTC P0604 displayed on the Subaru Select Monitor or OBD-II general scan tool? Replace the ECM. <Ref. to ENGINE CONTROL MODULE (ECM) . > Temporary poor contact occurs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.