Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Subaru Forester XT Limited, AutomaticFACTORY OEM SERVICE PROCEDURE

Intake Manifold: Disassembly

Remove the fuel pipe protector RH.

Fig 1: Locating Fuel Pipe Protector With Bolts (RH)
Remove the fuel pipe protector LH.

Fig 2: Locating Fuel Pipe Protector With Bolts (LH)
Remove the engine ground terminal from the intake manifold.

Fig 3: Locating Engine Ground Terminal On Intake Manifold

Chapter Navigation

Return to Chapter: Intake Manifold

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.