2006 Subaru Forester XT Limited, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Pump: Installation

Install in the reverse order of removal. Perform the following.

NOTE: Use a new gasket and retainer.
  1. Make sure the sealing portion is free from fuel or foreign matter before installation.
  2. Tighten the nuts in alphabetical sequence shown in the figure to the specified torque.

    Tightening torque:Β 

    4.4 N.m (0.45 kgf-m, 3.3 ft-lb)Β 

Fig 1: Nuts Sequence For Installing Fuel Pump Assembly Onto Fuel Tank
G04998458
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.