2006 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

Mode $06

Refer to test value of troubleshooting and data of test limit indicated on the support data bit sequence table. A list of the support data is shown in the following table.

SUPPORT DATA MODE $06

TID CID Test value & Test limit
$41 $81 $02 Rear oxygen sensor circuit (Bank 1 Sensor 2)
$81 $01 Catalyst system
$82 $01 $02 Exhaust gas recirculation system
$83 $01 Evaporative emission control system (0.04 inch leak)
$02 Evaporative emission control system (0.04 inch leak)
$03 Evaporative emission control system (0.04 inch leak)
$04 Evaporative emission control system (0.04 inch leak)
$05 Evaporative emission control system (0.02 inch leak)
$06 Evaporative emission control system (0.02 inch leak)
$84 $01 Front oxygen (A/F) sensor response (Bank 1 Sensor 1)
$85 L $01 Rear oxygen sensor response (Bank 1 Sensor 2) Rich β†’ Lean
$02 Rear oxygen sensor response (Bank 1 Sensor 2) Lean β†’ Rich
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.