Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE
Draining Fuel
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
- Set the vehicle on a lift.
- Disconnect the ground cable from battery.
- Open the fuel filler flap lid, and remove the fuel filler cap.
- Lift-up the vehicle.
- Drain fuel from fuel tank.
Set a container under the vehicle and remove the fuel drain plug from the fuel tank.
- Tighten the fuel drain plugs.
NOTE:
Use a new gasket.
Tightening torque: 26 N.m (2.65 kgf-m, 19.2 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.