Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Tank: Removal
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
- Set the vehicle on a lift.
- Release the fuel pressure.
<Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, FUEL. >
- Drain fuel from fuel tank.
<Ref. to DRAINING FUEL , PROCEDURE, FUEL. >
- Remove the rear seat.
- Disconnect the connector (A) between the fuel tank cord and the rear harness.
- Push the grommet (B) which holds the fuel tank cord on the floor panel into under the body.
- Remove the rear crossmember. <Ref. to REMOVAL Rear Crossmember . >
- Remove the canisters. <Ref. to REMOVAL , Canister. >
- Disconnect the connector from the pressure control solenoid valve.
- Loosen the clamp and disconnect the fuel filler hose (A) and evaporation hose from the fuel filler pipe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.