2006 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Release the fuel pressure.

    <Ref. to RELEASING OF FUEL PRESSUREΒ , PROCEDURE, FUEL. >

  2. Remove the battery. <Ref. to REMOVAL , Battery. >
  3. Open the fuel filler flap lid, and remove the fuel filler cap.
  4. Remove the spark plug cords from spark plugs (#2 and #4 cylinders).
  5. Remove the fuel pipe protector LH.
    Fig 1: Locating Fuel Pipe Protector LH
    G04997360
  6. Disconnect the connectors (A) from fuel injector.
  7. Remove the harness band (B) which holds the engine harness to injector pipe.
    Fig 2: Identifying Harness Band And Fuel Injector Connectors
    G04997362
  8. Remove the bolt which holds fuel injector pipe onto intake manifold.
    Fig 3: Locating Fuel Injector Pipe Bolts - LH Side
    G04997366
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.