Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor: Removal
- Disconnect the ground cable from battery.
- Disconnect the connector from camshaft position sensor.
- Remove the bolt which installs camshaft position sensor to support.
- Remove the bolt which installs camshaft position sensor support to camshaft cap LH.
- Remove the camshaft position sensor and the support as a unit.
- Remove the camshaft position sensor from the support.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.