2006 Subaru Baja Turbo, AutomaticFACTORY OEM SERVICE PROCEDURE

Front Hood Stay Installation

  • At the check and general maintenance 
    Fig 1: Identifying Front Hood Stay Installation Points
    G04987675Courtesy of SUBARU OF AMERICA, INC.
  • When wider hood opening is necessary 

Set stay into the hole of hood inner as shown in the figure below.

NOTE: Before setting the hood in this position, remove the windshield washer hose attaching clip from the hood.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.