Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Baja Base, StandardFACTORY OEM SERVICE PROCEDURE
Led Operation Mode For Engine
- On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
- Press the [YES] key after displayed the information of engine type.
- On the «Engine Diagnosis» display screen, select the {Current Data Display & Save} and press the [YES] key.
- On the «Data Display Menu» display screen, select the {Data & LED Display} and press the [YES] key.
- Using the scroll key, move the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.
SUPPORT DATA LIST
| Contents | Display | Message | LED "ON" requirements |
|---|---|---|---|
| Ignition switch signal | Ignition Switch | ON or OFF | When ignition switch is turned ON. |
| Test mode connector signal | Test Mode Signal | ON or OFF | When test mode connector is connected. |
| Neutral position switch signal | Neutral Position Switch | ON or OFF | When neutral position signal is entered. |
| Air conditioning switch signal | A/C Switch | ON or OFF | When air conditioning switch is turned ON. |
| Air conditioning relay signal | A/C Relay | ON or OFF | When air conditioning relay is in function. |
| Radiator main fan relay signal | Radiator Fan Relay #1 | ON or OFF | When radiator main fan relay is in function. |
| Fuel pump relay signal | Fuel Pump Relay | ON or OFF | When fuel pump relay is in function. |
| Knocking signal | Knocking Signal | ON or OFF | When knocking signal is entered. |
| Radiator sub fan relay signal | Radiator Fan Relay #2 | ON or OFF | When radiator sub fan relay is in function. |
| Engine torque control signal #1 | Torque Control Signal #1 | ON or OFF | When engine torque control signal 1 is entered. |
| Engine torque control signal #2 | Torque Control Signal #2 | ON or OFF | When engine torque control signal 2 is entered. |
| Engine torque control permission signal | Torque Control Permit | ON or OFF | When engine torque control permission signal is entered. |
| Front oxygen (A/F) sensor rich signal | Front O2 Rich Signal #1 | ON or OFF | When front oxygen (A/F) sensor mixture ratio is rich. |
| Rear oxygen sensor rich signal | Rear O2 Rich Signal | ON or OFF | When rear oxygen sensor mixture ratio is rich. |
| Pressure control solenoid valve | PCV Solenoid Valve | ON or OFF | When pressure control solenoid valve is in function. |
| Drain valve | Vent. Solenoid Valve | ON or OFF | When drain valve is in function. |
| Starter switch signal | Starter Switch Signal | ON or OFF | When starter switch signal is entered. |
| Idle switch signal | Idle Switch Signal | ON or OFF | When idle switch signal is entered. |
| Crankshaft position sensor signal | Crankshaft Position Sig. | ON or OFF | When crankshaft position sensor signal is entered. |
| Camshaft position sensor signal | Camshaft Position Sig. | ON or OFF | When camshaft position sensor signal is entered. |
| AT/MT discriminating terminal | AT vehicle ID signal | AT models/ MT models | AT models: ON |
| Rear defogger switch signal | Rear Defogger Switch | ON or OFF | Rear defogger switch: ON |
| Blower fan switch signal | Blower Fan Switch | ON or OFF | Blower fan switch: ON |
| Small light switch signal | Light Switch | ON or OFF | Small light switch: ON |
| Power steering switch signal | P/S switch | ON or OFF | When power steering switch signal is entered. |
| Fuel tank sensor control valve | Tank Sensor Cntl. Valve | ON or OFF | When fuel tank sensor control valve signal is entered. |
| Air assist injector solenoid valve signal | Assist Air Sol. Valve | ON or OFF | When air assist injector solenoid valve is activated. |
NOTE:
For detailed operation procedure, refer to the Subaru Select Monitor Operation Manual.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.