Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Baja Base, StandardFACTORY OEM SERVICE PROCEDURE
Power Window Control Switch: Inspection: Sub-Switch
Measure switch resistance.
Front passenger's door switch and rear door switch:Β
FRONT PASSENGER'S DOOR SWITCH AND REAR DOOR SWITCH REFERENCE
| Switch position | Terminal No. | Standard |
|---|---|---|
| UP | 5 and 1, 6 and 2 | Less than 1 Ξ© |
| OFF | 4 and 1, 6 and 2 | Less than 1 Ξ© |
| DOWN | 5 and 2, 4 and 1 | Less than 1 Ξ© |
If defective, replace the sub-switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.