2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

  1. Install the select cable to base plate.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  2. Install the select cable to range select lever.
  3. Install the plate assembly to transmission.

    Tightening torque: 

    T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb) 

    Fig 1: Identifying Select Cable And Plate Assembly
    G04990171Courtesy of SUBARU OF AMERICA, INC.
  4. Install the washer and snap pin to range select lever.
    Fig 2: Identifying Snap Pin, Clamp And Washer
    G04990172Courtesy of SUBARU OF AMERICA, INC.
  5. Move the select lever to "N" position, then adjust the select cable position. < Ref. to ADJUSTMENT , Select Cable. >
  6. Install the heat shield cover. (If equipped)
  7. Install the front and center exhaust pipe. (Non-TURBO model) < Ref. to INSTALLATION , FRONT EXHAUST PIPE. >
  8. Install center exhaust pipe. (TURBO model) < Ref. to INSTALLATION , CENTER EXHAUST PIPE. >
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.