2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Specification

Fig 1: Identifying AT Shift Lock Connector Terminal
G04990134Courtesy of SUBARU OF AMERICA, INC.
INPUT OUTPUT SIGNAL SPECIFICATIONS

Contents To Connector No. Terminal No. Input/Output signal
Measured value and measuring conditions
Battery power supply B281 2 9 - 16 V
Ignition power supply B280 19 10 - 15 V when ignition switch is at ON or START.
ACC power supply B280 10 10 - 15 V when ignition switch is at ACC or ON.
Inhibitor Switch ("P" position) B280 5 0 V when select lever is in "P" position. 9 - 16 V when select lever is in other positions than "P" position.
Stop light switch B280 9 9 - 16 V when stop light switch is ON. 0 V when stop light switch is OFF.
"P" position switch B280 6 0 V when select lever is in "P" position. 9 - 16 V when select lever is in other positions than "P" position.
Shift lock solenoid signal B281 9 8.5 - 16 V when shift lock is released. 0 V when shift lock is operating.
Key warning switch signal B280 20 9 - 16 V when key is inserted. 0 V when key is removed.
Key lock solenoid signal B281 3 Pulse is output when switching key lock between locked and unlocked. 0 V at other conditions than above.
Ground B281 4 -
Ground B281 13 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.