2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Extension Case: Installation

  1. Attach the selected thrust needle bearing to the end surface of reduction drive gear with vaseline.
    NOTE: Install thrust needle bearing in the correct direction.
  2. Install new gasket.
  3. Install the extension case to the transmission case.
  4. Tighten bolts to secure the case.

    Tightening torque: 25 N.m (2.5 kgf-m, 18.1 ft-lb)Β 

    Fig 1: Identifying Extension Case To Transmission Case
    G05002580Courtesy of SUBARU OF AMERICA, INC.
  5. Install the rear vehicle speed sensor.

    Tightening torque: 7 N.m (0.7 kgf-m, 5.1 ft-lb)Β 

    • MPT MODEL
      Fig 2: Identifying Rear Vehicle Speed Sensor And Front Vehicle Speed Sensor - MPT MODEL
      G04990433Courtesy of SUBARU OF AMERICA, INC.
    • VTD MODEL
      Fig 3: Identifying Rear Vehicle Speed Sensor And Front Vehicle Speed Sensor - VTD MODEL
      G04990434Courtesy of SUBARU OF AMERICA, INC.
  6. Install the transmission assembly. < Ref. to INSTALLATIONΒ . >
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.