Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Non-Turbo Model
- Set the range select lever in "N" range.
- Install the control valve, ATF temperature sensor and ground connectors.
Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb)
- Connect all connectors.
- Attach the magnet at specified position.
- Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
- Apply liquid gasket fully to three holes other than screw holes on transmission case.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
- Install the oil pan by equally tightening the bolts.
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)
- Pour ATF from the oil charge pipe.
Recommended fluid:
Dexron III
Fluid capacity: Fill the same amount of fluid drained from drain plug hole.
- Check the level of ATF.
< Ref. to AUTOMATIC TRANSMISSION FLUID . >
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.