Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Read Freeze Frame Data For Engine. (OBD Mode)
- On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
- Press the [YES] key after displayed the information of engine type.
- On the «Engine Diagnosis» display screen, select the {OBD System} and press the [YES] key.
- On the «OBD Menu» display screen, select the {Freeze Frame Data} and press the [YES] key.
- A list of the support data is shown in the following table.
SUPPORT DATA LIST
| Contents | Display | Unit of measure |
|---|---|---|
| Diagnostic trouble code (DTC) for freeze frame data | Freeze frame data | DTC |
| Air fuel ratio control system for bank 1 | Fuel system for Bank 1 | ON or OFF |
| Engine load data | Engine Load | % |
| Engine coolant temperature signal | Coolant Temp. | °C or °F |
| Short term fuel trim by front oxygen (A/F) sensor | Short term fuel trim B1 | % |
| Long term fuel trim by front oxygen (A/F) sensor | Long term fuel trim B1 | % |
| Intake manifold absolute pressure signal | Mani. Absolute Pressure | mmHg or kPa or inHg or psig |
| Engine speed signal | Engine Speed | rpm |
| Vehicle speed signal | Vehicle Speed | km/h or MPH |
| Ignition timing for #1 cylinder | Ignition Timing | ° |
| Intake air temperature | Intake Air Temp. | °C |
| Intake air amount | Mass Air Flow | g/sec |
| Throttle valve opening angle | Throttle Opening Angle | % |
NOTE:
For detailed operation procedure, refer to the Subaru Select Monitor Operation Manual.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.