2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Mode $06

Refer to test value of troubleshooting and data of test limit on support data bit sequence table. List of support data is shown in the following table.

SUPPORT DATA BIT SEQUENCE

TID CID Test value & Test limit
$41 $01 Rear oxygen sensor voltage diagnosis
$02
$44 $01 Front oxygen (A/F) sensor voltage diagnosis
$02
$81 $01 Catalyst system
$82 $01 EGR system
$02
$83 $01 Evaporative emission control system (0.04-inch leakage)
$02 Evaporative emission control system (0.04-inch leakage)
$03 Evaporative emission control system (0.04-inch leakage)
$04 Evaporative emission control system (0.04-inch leakage)
$05 Evaporative emission control system (0.02-inch leakage)
$06 Evaporative emission control system (0.02-inch leakage)
$84 $01 Front oxygen (A/F) sensor response diagnosis
$02
$85 $01 Rear oxygen sensor response diagnosis
$02
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.