Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Malfunction Indicator Lamp (MIL): Procedure
DIAGNOSTIC PROCEDURE
| 1. Activation of check engine malfunction indicator lamp (MIL). < Ref. to ACTIVATION OF CHECK ENGINE MALFUNCTION INDICATOR LAMP (MIL) . > |
| ↓ |
| 2. Check engine malfunction indicator lamp (MIL) does not come on. < Ref. to CHECK ENGINE MALFUNCTION INDICATOR LAMP (MIL) DOES NOT COME ON. . > |
| ↓ |
| 3. Check engine malfunction indicator lamp (MIL) does not go off. < Ref. to CHECK ENGINE MALFUNCTION INDICATOR LAMP (MIL) DOES NOT GO OFF. . > |
| ↓ |
| 4. Check engine malfunction indicator lamp (MIL) does not blink at a cycle of 3 Hz. < Ref. to CHECK ENGINE MALFUNCTION INDICATOR LAMP (MIL) DOES NOT BLINK AT A CYCLE OF 3 HZ. . > |
| ↓ |
| 5. Check engine malfunction indicator lamp (MIL) remains blinking at a cycle of 3 Hz. < Ref. to CHECK ENGINE MALFUNCTION INDICATOR LAMP (MIL) REMAINS BLINKING AT A CYCLE OF 3 HZ. . > |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
