Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE
AT Shift Lock System: Inspection: Notes
AT SHIFT LOCK SYSTEM REFERENCE
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK SHIFT LOCK.
|
While the brake pedal is depressed, can select lever move from "P" range to other positions? | Go to step 2. | Inspect "SELECT LEVER SHIFT LOCK CANNOT BE RELEASED". < Ref. to SELECT LEVER SHIFT LOCK CANNOT BE RELEASED , INSPECTION, AT Shift Lock System. > |
| 2 CHECK SHIFT LOCK. | While the brake pedal is not depressed, can select lever move from "P" range to other positions? | Inspect "SELECT LEVER CANNOT BE SHIFT LOCKED". < Ref. to SELECT LEVER CANNOT BE SHIFT LOCKED , INSPECTION, AT Shift Lock System. > | Go to step 3. |
| 3 CHECK KEY INTERLOCK. | When the select lever is in other than "P" position, does ignition switch turn to "LOCK" position? | Inspect "KEY INTERLOCK DOES NOT BE LOCKED OR RELEASED. < Ref. to SELECT LEVER SHIFT LOCK CANNOT BE RELEASED , INSPECTION, AT Shift Lock System. > | Go to step 4. |
| 4 CHECK KEY INTERLOCK. | When the select lever is in "P" position, does ignition switch turn to "LOCK" position? | AT shift lock system is normal. | Inspect "KEY INTERLOCK DOES NOT BE LOCKED OR RELEASED. < Ref. to SELECT LEVER SHIFT LOCK CANNOT BE RELEASED , INSPECTION, AT Shift Lock System. > |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
