Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Can Communication Signals Control
By interchanging information between control modules such as the TCM, ECM, ABSCM & H/U, etc., the modules are controlled in accordance with the vehicle's driving conditions.
In CAN (Controller Area Network) communication, each control module is connected with 2 lines and a large amount of information is interchanged through such a small number of wiring. Each control module sends and receives information and reads only the necessary information for its own purpose.
Main signals sent and received for transmission control
| TCM | ECM | ABSCM&H/U | Body integrated unit | Combination meter | |
|---|---|---|---|---|---|
| Sports mode switch-cum-manual mode switch signal | IN | OUT | |||
| Upshift signal (manual mode) | IN | OUT | |||
| Downshift signal (manual mode) | IN | OUT | |||
| Brake switch signal | IN | OUT | |||
| ABS signal | IN | OUT | |||
| ENG AT cooperation signal | IN | OUT | |||
| OUT | IN | ||||
| Range position signal | OUT | IN | IN/OUT | IN | |
| AT warning light signal (SPORT indicator light) | OUT | IN/OUT | IN | ||
| Sports shift warning buzzer signal | OUT | IN/OUT | IN | ||
| AWD warning light signal Also used as FWD indicator light signal | OUT | IN/OUT | IN | ||
| IN: received | |||||
| OUT: sent | |||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
