2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Keyless Entry Control Module

Fig 1: Identifying Keyless Entry Control Module Connector Terminal
G04991638Courtesy of SUBARU OF AMERICA, INC.
TERMINAL REFERENCE CHART

Content Terminal No. Measuring condition
Turn signal light (Left) 1 (OUTPUT) Battery voltage is present when pressing the transmitter UNLOCK/DISARM or LOCK/ARM button.
Power supply (Back-up) 2 Battery voltage is constantly present.
Keyless buzzer 3 (OUTPUT) 0 V is present when pressing the transmitter UNLOCK/DISARM or LOCK/ARM button.
Door lock switch 4 (INPUT) 0 V is present when unlocking the door lock switch.
Door lock switch 5 (INPUT) 0 V is present when locking the door lock switch.
Door switch 6 (INPUT) 0 V is present when any door is opened.
Key warning switch 9 (INPUT) Battery voltage is present when inserting the key into the ignition switch.
Ignition switch (ON) 10 (INPUT) Battery voltage is present when ignition switch is turned to ON.
Turn signal light (Right) 13 (OUTPUT) Battery voltage is present when pressing the transmitter UNLOCK/DISARM or LOCK/ARM button.
Ground 14 0 V is constantly present.
Integrated module 18 (OUTPUT) 0 V is present when pressing the transmitter UNLOCK/DISARM button.
Integrated module 19 (OUTPUT) 0 V is present when pressing the transmitter LOCK/ARM button.
Horn relay 24 (OUTPUT) 0 V is present when pressing the transmitter LOCK/ARM for approximately 2 seconds and the panic alarm is activated.
Power supply (Back-up) 26 Battery voltage is constantly present.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.