Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Function Setting (Customize Unit)
- Connect the SUBARU Select Monitor to the data link connector.
- Turn the ignition switch ON.
- Select {CHECK INDIVIDUAL SYSTEM} on the «MAIN MENU» screen, and then press the [YES] key.
- Select {KEYLESS UNIT MODE} on the «SYSTEM SELECT MENU» screen, and then press the [YES] key.
- Select {CUSTOMIZE UNIT} on the «INTEGRATED UNIT MODE DIAGNOSIS» screen, and then press the [YES] key.
- Change the contents using the UP/DOWN key, and then set using the [YES] key.
- Function Setting (Customize Unit) Item ListFUNCTION SETTING (CUSTOMIZE UNIT) ITEM LIST
No. Data Initial setting Customized setting Remarks 1 Alarm ON/OFF setting ON ON Operates the alarm (hazard, horn). OFF Stops the alarm operation. 2 Alarm monitoring delay setting ON After keyless locking, the alarm monitoring operates after the following delay time. ON The delay time is 30 seconds. OFF The delay time is 0 seconds. 3 Impact sensor ON/OFF setting OFF ON Activates the impact sensor function when the setting of the impact sensor is "YES". OFF Deactivates the impact sensor function. (For the models without the impact sensor, it should set to "OFF".) 4 Setting with/without impact sensor (Option) NO YES Controls the impact sensor mounted mode. [For the models without the impact sensor, it should be set to "NO". If it is set to "YES", the hazard or horn operates under the keyless lock (start alarm monitoring).] NO Controls the impact sensor not mounted mode. 5 Passive ARM switching OFF ON The function automatically shifts to ARM even if the user does not lock (ARM) it on purpose. OFF Activates when the passive ARM switching is set to "ON".
- Function Setting (Customize Unit) Item List
- After completing the setting, make sure that the contents of the change are adapted to the vehicle equipment in {CURRENT DATA DISPLAY/STORE}.CAUTION:
- The alarm is operated normally by matching the above setting and the vehicle equipment specification.
- Do not change the setting for items other than the above items during the function setting operation.
- Perform resetting when installing a new keyless unit.
- In the passive mode, the security alarm is operated automatically, but the doors are not locked. At this time, always lock the doors to prevent crime because it is very dangerous.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
