2006 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Electrical Specification

CAUTION: Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.
ELECTRICAL SPECIFICATION

Terminal Name Terminal No. Input/Output value Remarks
IG - power supply 9 9 - 16V When ignition switch ON
Airbag control module communication (COM) 10 Open collector terminal Communication line
Airbag control module communication (GND) 5 0V Ground
Belt tension sensor (Vcc) 5 0 - 5V Bert tension sensor power supply
(Vout) 16 0.5 - 4.5 V Sensor output voltage
(GND) 14 0 V Sensor ground
Occupant detection sensor (Vcc) 6 0 -5V Pressure sensor power supply
(Vout) 7 0.5 -4.5 V Sensor output voltage
(GND) 15 0 V Sensor ground
Buckle switch 1 0 - IG voltage Ignition voltage when switch ON
Buckle switch (GND) 2 0 V Switch ground
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.