2006 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE

SUBARU Select Monitor

  1. After clearing the memory, check for any remaining unresolved trouble data. < Refer to CLEAR MEMORY MODE . >
  2. Idle the engine.
  3. Prepare the Subaru Select Monitor kit. < Refer to PREPARATION TOOL , GENERAL DESCRIPTION. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the diagnosis cable to Subaru Select Monitor.
  5. Insert the cartridge to Subaru Select Monitor. < Refer to PREPARATION TOOL , GENERAL DESCRIPTION. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014Courtesy of SUBARU OF AMERICA, INC.
  6. Connect the test mode connector (A) located under the glove box.
    Fig 3: Connecting Test Mode Connector Under Glove Box
    G05031674Courtesy of SUBARU OF AMERICA, INC.
  7. Connect the Subaru Select Monitor to the data link connector at the lower portion of instrument panel (on the driver's side).
    Fig 4: Locating Data Link Connector
    G05031666Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Procedure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.