2006 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Fuel Tank: Installation

  1. Install the fuel tank to the vehicle.
    WARNING: A helper is required to perform this work.
    1. Lift the fuel tank with the transmission jack.
    2. Mount the fuel tank to the vehicle with a jack.
    3. Install the fuel tank band that holds the fuel tank.

    Tightening torque: 

    33 N.m (3.4 kgf-m, 25 ft-lb) 

    Fig 1: Locating Fuel Tank Band
    G05031089Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the following hoses and connectors.
    1. Evaporation hose
    2. Fuel filler hose
    3. Connector
    Fig 2: Identifying Fuel Filler And Evaporation Hose
    G05031091Courtesy of SUBARU OF AMERICA, INC.
  3. Install the rear suspension assembly. < Refer to INSTALLATION , Rear Sub Frame. >
  4. Install the clip that holds the harness.
    Fig 3: Locating Harness Holding Clip
    G05031087Courtesy of SUBARU OF AMERICA, INC.
  5. Lower the vehicle.
  6. Install the rear wheels.
  7. Connect the quick connector on fuel delivery hose. < Refer to INSTALLATION , FUEL DELIVERY, RETURN AND EVAPORATION LINES. >
  8. Install the service hole cover of fuel sub level sensor.
    Fig 4: Locating Service Hole Cover
    G05031085Courtesy of SUBARU OF AMERICA, INC.
  9. Install the service hole cover of fuel pump.
    1. Push on the grommet to install it to the second hole cover.
    2. Tighten the bolt.
    3. Connect the connector.
    Fig 5: Identifying Grommet And Connector
    G05031094Courtesy of SUBARU OF AMERICA, INC.
  10. Install the second seat. < Refer to INSTALLATION , Second-row Seats. >
  11. Install the fuse of fuel pump to main fuse box.
  12. Connect the battery ground cable to the battery.
Chapter Navigation
Return to Chapter: Fuel Tank
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.