Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru B9 Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Fuel Sub Level Sensor: Removal
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
- Drain fuel. < Refer to DRAINING FUEL , PROCEDURE, FUEL. >
- Remove the second seat. < Refer to REMOVAL , Second-row Seats. >
- Remove the service hole cover.
- Disconnect the connector from the fuel sub level sensor.
- Disconnect the quick connector, and then disconnect the fuel delivery hose, return hose and jet pump hose. < Refer to REMOVAL , FUEL DELIVERY, RETURN AND EVAPORATION LINES. >
- Remove the nuts and bolts which install fuel sub level sensor on fuel tank.
- Remove the fuel sub level sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.