SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSOUTER MIRROR ASSEMBLYINSPECTION
2005 Subaru Outback i, Standard

Outer Mirror Assembly: Inspection

2005 Subaru Outback i, StandardSECTION Inspection

Check that the rearview mirror moves properly when the battery voltage is applied to terminals.

  • Model with side turn signal light
    SWITCH POSITION TERMINAL SPECIFICATION

    Switch position Terminal No.
    OFF -
    UP 6 (+) and 3 (-) or 8 (-)
    DOWN 3 (+) or 8 (+) and 6 (-)
    LEFT 7 (+) and 3 (-) or 8 (-)
    RIGHT 3 (+) or 8 (+) and 7 (-)
  • Model without side turn signal light
Fig 1: Model With Side Turn Signal Light Connector Terminal
G03833698Courtesy of SUBARU OF AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.