2005 Subaru Outback XT, AutomaticFACTORY OEM SERVICE PROCEDURE

Mode $06

Refer to test value of troubleshooting and data of test limit on support data bit sequence table. List of support data is shown in CLEAR/RESET EMISSION-RELATED DIAGNOSTIC INFORMATION (MODE $04)Β  .

CLEAR/RESET EMISSION-RELATED DIAGNOSTIC INFORMATION (MODE $04)

TID CID Test value & Test limit
$81 $01 Catalyst system efficiency
$83 $01 Evaporative emission control system 0.04 inch leak
$02 Evaporative emission control system 0.04 inch leak
$03 Evaporative emission control system 0.04 inch leak
$04 Evaporative emission control system 0.04 inch leak
$05 Evaporative emission control system 0.02 inch leak
$86 Evaporative emission control system 0.02 inch leak
$84 $01 A/F sensor circuit slow response (Bank 1 Sensor 1)
$85 $01 O2 sensor circuit (Bank 1 Sensor 2) (rich --> lean)
$02 O2 sensor circuit (Bank 1 Sensor 2) (lean --> rich)
$41 $81 O2 sensor circuit (Bank 1 Sensor 2)
$02 O2 sensor circuit (Bank 1 Sensor 2)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.