2005 Subaru Outback XT, AutomaticFACTORY OEM SERVICE PROCEDURE

Mode $02 (Powertrain Freeze Frame Data)

Refer to data denoting the operating condition when trouble is detected by the on-board diagnosis system.

A list of the support data and PID (Parameter Identification) codes are shown in POWERTRAIN FREEZE FRAME DATA (MODE $02)  .

POWERTRAIN FREEZE FRAME DATA (MODE $02)

PID Data Unit of measure
02 DTC that caused CARB required freeze frame data storage -
03 Fuel system control status -
04 Calculated engine load value %
05 Engine coolant temperature °C
06 Short term fuel trim %
07 Long term fuel trim %
0B Intake manifold absolute pressure kPa
0C Engine speed rpm
0D Vehicle speed MPH
0E Ignition timing advance °
0F Intake air temperature °C
10 Air flow rate from mass air flow sensor g/sec
11 Throttle valve opening angle %
NOTE: Refer to OBD-II general scan tool manufacturer's operation manual to access freeze frame data (MODE $02).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.