2005 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Select Lever: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Shift the select lever to "N" range.
  4. Lift-up the vehicle.
  5. Remove the rear exhaust pipe and muffler.
    • SOHC model

      < Ref. to REMOVAL , Rear Exhaust Pipe.> < Ref. to REMOVAL , Muffler. >

    • DOHC turbo model

      < Ref. to REMOVAL , Rear Exhaust Pipe.> < Ref. to REMOVAL , Muffler. >

    • DOHC 3.0 L model

      < Ref. to REMOVAL , Rear Exhaust Pipe.> < Ref. to REMOVAL , Muffler. >

  6. Remove the heat shield cover.
    Fig 1: Removing Heat Shield Cover
    G03831030Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the cable from arm assembly.
    Fig 2: Removing Cable From Arm Assembly
    G03831031Courtesy of SUBARU OF AMERICA, INC.
  8. Raise the pawl of clamp to remove the cable.
    Fig 3: Identifying Claw
    G03831032Courtesy of SUBARU OF AMERICA, INC.
  9. Lower the vehicle.
  10. Remove the console box. < Ref. to REMOVAL , Console Box. >
  11. Remove the center console. < Ref. to REMOVAL , Center Console. >
  12. Remove the harness clips from bracket.
    Fig 4: Locating Harness Clips
    G03831033Courtesy of SUBARU OF AMERICA, INC.
  13. Disconnect the connectors, and then remove the four bolts to take out the select lever assembly from vehicle body.
    Fig 5: Removing Bolts
    G03831034Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.