Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Learning Control: Procedure
- Turn the ignition switch to OFF.
- Turn the air conditioner switch to OFF.
- Turn the headlight switch to OFF.
- Turn the rear defogger switch to OFF.
- Start the engine.
- Connect the Subaru Select Monitor to the vehicle.
- Drive the vehicle for 5- 10 km (3- 6 miles) to warm up ATF temperature more than 70 °C (158 °F).
- With the throttle opening angle on Subaru Select Monitor indicates between 10%+/-2%, shift the gear from 1st --> 2nd, 2nd --> 3rd, 3rd --> 4th, 4th --> 5th while driving the vehicle at "D" range. < Ref. to , READ CURRENT DATA , OPERATION, Subaru Select Monitor. >
- Repeat the step 8) until reducing of shifting shock was felt.
- If reducing of shifting shock is not felt after 5 cycles, recheck that the learning conditions (throttle opening angle, ATF temperature, etc.) are as specified and recheck that other parts are normal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.