2005 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

Front Strut: Disposal

CAUTION:
  • Before handling struts, be sure to wear goggles to protect eyes from gas, oil and cutting powder.
  • Do not disassemble the strut damper or place into a fire.
  • Drill a hole into struts in case of discarding struts filled with gas.
  1. Place the strut on a level surface with the piston rod fully expanded.
  2. Using a 2 to 3 mm (0.08 to 0.12 in) dia. drill, make holes in areas shown in Fig 1 .
Fig 1: Identifying Drilled Hole
G03832314Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.