2005 Subaru Outback RFACTORY OEM SERVICE PROCEDURE

General Diagnostic Table: Inspection

GENERAL DIAGNOSTIC SPECIFICATION

Symptom Problem parts
Passenger's airbag ON/OFF indicator does not operate.
  • Load cell sensor is faulty.
  • Airbag ON/OFF indicator is faulty.
  • Condition of installation for passenger's seat is faulty.
  • Damage for passenger's seat
  • Damage for floor panel
Passenger's seat belt warning does not operate properly.
  • Buckle switch is faulty.
  • Buckle switch harness is faulty.
  • Occupant detection control module is faulty.
  • Passenger's seat control module harness is faulty.
  • Damage for passenger's seat
The airbag warning light comes on.
  • Combination meter is faulty.
  • Airbag control module is faulty.
  • Steering roll connector is faulty.
  • Each airbag module is faulty.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.