Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Section 46 (Lighting System): General Description: Specifications
WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL DESCRIPTION
| Headlight | Single-bulb type | 12 V - 55/65 W |
|---|---|---|
| Dual-bulb type | 12 V - 55 W (Low) 12 V - 60 W (High) |
|
| Front turn signal light, side turn signal light, parking light | 12 V - 27/8 W | |
| Front fog light | 12V - 51 W | |
| Rear combination light | Tail/Stop/Turn signal light | 12V - 21/5W |
| Back-up light | 12V - 21 W | |
| Rear finisher light | Tail light | 12V - 5W |
| License plate light | 12V - 5W | |
| High-mounted stop light | 12V - 13W | |
| Room light | 12V - 8W | |
| Spot light | 12V - 8W | |
| Door step light | 12 V - 3.4 W | |
| Glove box light | 12V - 1.4W | |
| Cargo light | 12V - 13W | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
