Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Mode $02 (Powertrain Freeze Frame Data)
Refers to data denoting the operating condition when trouble is sensed by the on-board diagnosis system. A list of the support data and PID (Parameter Identification) codes are shown in the following table.
DTC CHART
| PID | Data | Unit of measure |
|---|---|---|
| 02 | DTC that caused CARB required freeze frame data storage | - |
| 03 | Fuel system control status | - |
| 04 | Calculated engine load value | % |
| 05 | Engine coolant temperature | °C |
| 06 | Short term fuel trim (bank 1) | % |
| 07 | Long term fuel trim (bank 1) | % |
| 08 | Short term fuel trim (bank 2) | % |
| 09 | Long term fuel trim (bank 2) | % |
| 0B | Intake manifold absolute pressure | kPa |
| 0C | Engine speed | RPM |
| 0D | Vehicle speed | km/h |
NOTE:
Refer to OBD-II general scan tool manufacturer's instruction manual to access freeze frame data (MODE $02).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.