Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback Limited, StandardFACTORY OEM SERVICE PROCEDURE
SUBARU Select Monitor (Normal Mode)
- On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
- On the "System Selection Menu" display screen, select the {Engine} and press the [YES] key.
- Press the [YES] key after the information of engine type has been displayed.
- On the "Engine Diagnosis" screen, select the {DTC Display}, and then press the [YES] key.
- On the "Diagnostic Code(s) Display" screen, select the {Current Diagnostic Code(s)} or {History Diagnostic Code(s)}, and then press the [YES] key.
NOTE:
- For detailed operation procedure, refer to " SUBARU SELECT MONITOR OPERATION MANUAL ".
- For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE DTC .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.