Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback F6-3.0LFACTORY OEM SERVICE PROCEDURE
Power Window Switch: Service and Repair
Power Window Control Switch
REMOVAL
1. MAIN SWITCH
1. Disconnect the ground cable from battery.
2. Remove the front door trim.
3. Disconnect the harness connector.
4. Remove the screws from the reverse side of front door trim to remove the power window main switch.
2. SUB SWITCH
1. Disconnect the ground cable from battery.
2. Remove the door trim.
3. Disconnect the connector.
4. Remove the screws from the reverse side of door trim to remove the power window sub switch.
INSTALLATION
1. MAIN SWITCH
Install in the reverse order of removal.
2. SUB SWITCH
Install in the reverse order of removal.
REMOVAL
1. MAIN SWITCH
1. Disconnect the ground cable from battery.
2. Remove the front door trim.
3. Disconnect the harness connector.
4. Remove the screws from the reverse side of front door trim to remove the power window main switch.
2. SUB SWITCH
1. Disconnect the ground cable from battery.
2. Remove the door trim.
3. Disconnect the connector.
4. Remove the screws from the reverse side of door trim to remove the power window sub switch.
INSTALLATION
1. MAIN SWITCH
Install in the reverse order of removal.
2. SUB SWITCH
Install in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.