Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback F6-3.0LFACTORY OEM SERVICE PROCEDURE
Scan Tool Testing and Procedures
Inspection Mode
PROCEDURE
WARNING: Observe the traffic law during driving the public road.
1. Shift the select lever to D range, and then drive the vehicle with changing the gear from 1st to 5th.
2. When driving the vehicle at 5th speed of D range, set the gear to manual mode and drive the vehicle with shifting down using "-" of steering switch or "-" of select lever from 5th -> 4th, 4th -> 3rd, 3rd -> 2nd, 2nd -> 1st.
NOTE: At shifting down, drive the vehicle at least 10 seconds in each speed.
3. Shift the select lever to "R" range and drive the vehicle for more than 2 seconds.
PROCEDURE
WARNING: Observe the traffic law during driving the public road.
1. Shift the select lever to D range, and then drive the vehicle with changing the gear from 1st to 5th.
2. When driving the vehicle at 5th speed of D range, set the gear to manual mode and drive the vehicle with shifting down using "-" of steering switch or "-" of select lever from 5th -> 4th, 4th -> 3rd, 3rd -> 2nd, 2nd -> 1st.
NOTE: At shifting down, drive the vehicle at least 10 seconds in each speed.
3. Shift the select lever to "R" range and drive the vehicle for more than 2 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.