Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback F6-3.0LFACTORY OEM SERVICE PROCEDURE
Trunk / Liftgate Lock: Service and Repair
Trunk Lid Lock Assembly
REMOVAL
1. Remove the trunk lid release handle.
2. Disconnect the connectors and detach the cable of trunk opener.

3. Remove the two bolts to remove trunk lid lock assembly.
INSTALLATION
Install in the reverse order of removal.
NOTE:
- Apply grease to the movable part.
- Make sure the lock works correctly after installation.
REMOVAL
1. Remove the trunk lid release handle.
2. Disconnect the connectors and detach the cable of trunk opener.
3. Remove the two bolts to remove trunk lid lock assembly.
INSTALLATION
Install in the reverse order of removal.
NOTE:
- Apply grease to the movable part.
- Make sure the lock works correctly after installation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
