Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
2.5L SOHC
Fuel Sub Level Sensor
REMOVAL
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
1. Drain fuel.
2. Remove the rear seat.

3. Remove the service hole cover.
1. Remove the bolts (A).
2. Push the grommet (B) down under the body and remove the service hole cover.

4. Disconnect the connector from fuel sub level sensor.
5. Disconnect the quick connector and then disconnect the fuel deliver hose, return hose and jet pump hose.

6. Remove the nuts and bolts which install the fuel sub level sensor on fuel tank.
7. Remove the fuel sub level sensor
INSTALLATION
Install in the reverse order of removal.
NOTE: Use a new gasket.
1. Ensure the sealing portion is free from fuel or foreign articles before installation.

2. Tighten the nuts and bolts to specified torque in the order a shown in the figure.
REMOVAL
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
1. Drain fuel.
2. Remove the rear seat.
3. Remove the service hole cover.
1. Remove the bolts (A).
2. Push the grommet (B) down under the body and remove the service hole cover.
4. Disconnect the connector from fuel sub level sensor.
5. Disconnect the quick connector and then disconnect the fuel deliver hose, return hose and jet pump hose.
6. Remove the nuts and bolts which install the fuel sub level sensor on fuel tank.
7. Remove the fuel sub level sensor
INSTALLATION
Install in the reverse order of removal.
NOTE: Use a new gasket.
1. Ensure the sealing portion is free from fuel or foreign articles before installation.
2. Tighten the nuts and bolts to specified torque in the order a shown in the figure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
