Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
2.5L SOHC
Engine Control Module (ECM)
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the lower inner trim of passenger's side.
3. Detach the floor mat of front passenger seat.
4. Remove the protect cover.
5. Remove the bolt and nut which hold the ECM to bracket.
6. Remove the clip (A) from bracket.
7. Disconnect the ECM connectors and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
- When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage to fuel injection system.
- When replacing the ECM, be careful not to damage the harnesses and connectors.
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the lower inner trim of passenger's side.
3. Detach the floor mat of front passenger seat.
4. Remove the protect cover.
5. Remove the bolt and nut which hold the ECM to bracket.
6. Remove the clip (A) from bracket.
7. Disconnect the ECM connectors and take out the ECM.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
- When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage to fuel injection system.
- When replacing the ECM, be careful not to damage the harnesses and connectors.
Tightening torque: 5 N.m (0.5 kgf-m, 3.6 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.