2005 Subaru Baja Base, StandardFACTORY OEM SERVICE PROCEDURE

Led Operation Mode For Engine

  1. On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
  2. On the << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after displayed the information of engine type.
  4. On the << Engine Diagnosis >> display screen, select the {Current Data Display & Save} and press the [YES] key.
  5. On the << Data Display Menu >> display screen, select the {Data & LED Display} and press the [YES] key.
  6. Using the scroll key, move the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
      SUPPORT DATA LIST (LED OPERATION MODE ENGINE)

      Contents Display Message LED "ON" requirements
      Ignition switch signal Ignition Switch ON or OFF When ignition switch is turned ON.
      Test mode connector signal Test Mode Signal ON or OFF When test mode connector is connected.
      Neutral position switch signal Neutral Position Switch ON or OFF When neutral position signal is entered.
      Air conditioning switch signal A/C Switch ON or OFF When air conditioning switch is turned ON.
      Air conditioning relay signal A/C Relay ON or OFF When air conditioning relay is in function.
      Radiator main fan relay signal Radiator Fan Relay #1 ON or OFF When radiator main fan relay is in function.
      Fuel pump relay signal Fuel Pump Relay ON or OFF When fuel pump relay is in function.
      Knocking signal Knocking Signal ON or OFF When knocking signal is entered.
      Radiator sub fan relay signal Radiator Fan Relay #2 ON or OFF When radiator sub fan relay is in function.
      Engine torque control signal #1 Torque Control Signal #1 ON or OFF When engine torque control signal 1 is entered.
      Engine torque control signal #2 Torque Control Signal #2 ON or OFF When engine torque control signal 2 is entered.
      Engine torque control permission signal Torque Control Permit ON or OFF When engine torque control permission signal is entered.
      Front oxygen (A/F) sensor rich signal Front O2 Rich Signal #1 ON or OFF When front oxygen (A/F) sensor mixture ratio is rich.
      Rear oxygen sensor rich signal Rear O2 Rich Signal ON or OFF When rear oxygen sensor mixture ratio is rich.
      Pressure control solenoid valve PCV Solenoid Valve ON or OFF When pressure control solenoid valve is in function.
      Drain valve Vent. Solenoid Valve ON or OFF When drain valve is in function.
      Starter switch signal Starter Switch Signal ON or OFF When starter switch signal is entered.
      Idle switch signal Idle Switch Signal ON or OFF When idle switch signal is entered.
      Crankshaft position sensor signal Crankshaft Position Sig. ON or OFF When crankshaft position sensor signal is entered.
      Camshaft position sensor signal Camshaft Position Sig. ON or OFF When camshaft position sensor signal is entered.
    NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.