2005 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Transmission Control Device: Removal

  1. Remove the transmission assembly from the vehicle. < Ref. to , REMOVAL . >
  2. Extract the torque converter clutch assembly. < Ref. to , REMOVAL . >
  3. Remove the input shaft.
  4. Lift-up the lever behind the transmission harness connector and disconnect it from stay.
  5. Disconnect the air breather hoses. < Ref. to , REMOVAL . >
  6. Disconnect the inhibitor switch connector from stay.
  7. Wrap the nipple attached to the air breather hose around with a vinyl tape.
  8. Remove pitching stopper bracket.
  9. Remove the inhibitor switch.
    Fig 1: Removing Pitching Stopper Bracket
    G03750810Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the control valve body assembly. < Ref. to , REMOVAL . >
  11. Pull off the straight pin of manual plate.
    Fig 2: Pulling Off Straight Pin Of Manual Plate
    G03750811Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the bolts securing select lever, then remove the select lever, manual plate and parking rod.
    NOTE: Be careful not to damage the lips of the press-fitted oil seal in the case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.