Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Enter Identification Mode
- Open the driver's door and leave it open.NOTE: Check if the battery cable is connected.
- Turn the ignition switch from ON to LOCK two times. (LOCK --> ON --> LOCK --> ON --> LOCK)
- The indicator light will start blinking.INDICATOR LIGHT BLINKING
Number of times blinked Vehicle state 1 time Any door, rear gate or trunk lid has been opened. 3 times The impact sensor in the system's unit has been activated. This may indicate that your vehicle has been shocked or tampered with by some outside force and/or unauthorized person. 4 times The ignition switch has been turned ON, or the battery has been disconnected. - Close the door and turn the ignition switch to ON in order to disarm the identification mode.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.