2004 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Release fuel pressure. Refer to FUELΒ .
  2. Open fuel flap lid, and remove fuel filler cap.
  3. Disconnect ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G00897259Courtesy of SUBARU OF AMERICA, INC.
  4. Remove two bolts which install washer tank on body.
    Fig 2: Removing Washer Tank Bolts
    G00897260Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect connector from front window washer motor.
  6. Disconnect connector from rear gate glass washer motor.
    Fig 3: Disconnecting Gate Glass Washer Motor Connector
    G00897261Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect rear window glass washer hose from washer motor, then plug connection with a suitable cap.
  8. Move washer tank upward.
    Fig 4: Moving Washer Tank Upward
    G00897262Courtesy of SUBARU OF AMERICA, INC.
  9. Remove ground cable from fuel pipe protector LH.
    Fig 5: Removing Ground Cable
    G00897263Courtesy of SUBARU OF AMERICA, INC.
  10. Remove fuel pipe protector LH.
    Fig 6: Removing Fuel Pipe Protector
    G00897264Courtesy of SUBARU OF AMERICA, INC.
  11. Disconnect connector (A) from fuel injector.
  12. Remove bolt (B) which holds injector pipe onto cylinder head.
    Fig 7: Removing Injector Pipe Bolt
    G00897265Courtesy of SUBARU OF AMERICA, INC.
  13. Remove fuel injector while lifting up fuel injector pipe.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.