Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Subaru Outback F6-3.0LFACTORY OEM SERVICE PROCEDURE
Repair and Diagnosis: Application and ID
IDENTIFICATION
1. IDENTIFICATION NUMBER AND LABEL LOCATIONS
The VIN (Vehicle Identification Numbers) is used to classify the vehicle. Positioning of the plate label for identification.
2. MEANING OF VIN
The meaning of the VIN is as follows:
Legacy, OUTBACK
]4S3BE635X47200001[
The starting and ending brackets (][) are stop marks.
PICKUP
]4S4BT61CX46100001[
The starting and ending brackets (][) are stop marks.
3. MODEL NUMBER PLATE
The model number plate indicates: the applied model, the option code, the trim code, the engine type, the transmission type, and the exterior color code. This information is helpful when placing orders for parts.
The engine and transmission type are as follows:
- Engine
- Transmission
- Rear differential 1
- Rear differential 2
1. IDENTIFICATION NUMBER AND LABEL LOCATIONS
The VIN (Vehicle Identification Numbers) is used to classify the vehicle. Positioning of the plate label for identification.
2. MEANING OF VIN
The meaning of the VIN is as follows:
]4S3BE635X47200001[:
Legacy, OUTBACK
]4S3BE635X47200001[
The starting and ending brackets (][) are stop marks.
]4S4BT61CX46100001[:
PICKUP
]4S4BT61CX46100001[
The starting and ending brackets (][) are stop marks.
3. MODEL NUMBER PLATE
BE9EY3J:
The model number plate indicates: the applied model, the option code, the trim code, the engine type, the transmission type, and the exterior color code. This information is helpful when placing orders for parts.
The engine and transmission type are as follows:
EZ30DAXCBB:
- Engine
TY754VCDAA:
- Transmission
VA1REG (XJ):
- Rear differential 1
T1:
- Rear differential 2
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.