Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Subaru Forester XT, StandardFACTORY OEM SERVICE PROCEDURE
Exhaust Temperature Sensor: Removal
- Disconnect the ground cable from battery.
- Remove the joint pipe. < Ref. to REMOVAL , Joint Pipe . >
- Apply SUBARU CRC or its equivalent to the threaded portion of exhaust temperature sensor, and leave it for 1 minute or more.
- SUBARU CRC (Part No. 004301003)
- Remove the exhaust temperature sensor.CAUTION: When Identifying the exhaust temperature sensor, wait until the exhaust pipe cools, otherwise it will damage exhaust pipe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.