2004 Subaru Forester XT, AutomaticFACTORY OEM SERVICE PROCEDURE

Transmission Control Device: Removal

  1. Remove the transmission assembly from the vehicle. < Ref. to A: REMOVAL . >
  2. Extract the torque converter clutch assembly. < Ref. to A: REMOVAL . >
  3. Remove the input shaft.
  4. Lift-up lever behind the transmission harness connector and disconnect it from stay.
  5. Disconnect the air breather hoses. < Ref. to A: REMOVAL . >
  6. Disconnect inhibitor switch connector from stay.
  7. Wrap vinyl tape around the nipple attached to the air breather hose.
  8. Remove pitching stopper bracket.
  9. Remove the inhibitor switch.
    Fig 1: Identifying Pitching Stopper Bracket
    G00936495Courtesy of SUBARU OF AMERICA, INC.
  10. Remove control valve body assembly. < Ref. to A: REMOVAL . >
  11. Pull off the spring pin of manual plate.
    Fig 2: Pulling Off Spring Pin Of Manual Plate
    G00936496Courtesy of SUBARU OF AMERICA, INC.
  12. Remove bolts securing range select lever, then remove range select lever, manual plate and parking rod.
    NOTE: Be careful not to damage the lips of the press-fitted oil seal in the case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.