Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Select Cable: Removal
- Set the vehicle on a lift.
- Disconnect the ground cable from battery.
- Prior to removal, set the lever to "N" range.
- Lift-up the vehicle.
- Remove the front and center exhaust pipe.
Non-turbo model
< Ref. to REMOVAL , Front Exhaust Pipe . >
Turbo model
< Ref. to REMOVAL , Front Exhaust Pipe . >
- Remove the heat shield cover. (If equipped)
- Remove the snap pin from range select lever.
- Remove the plate assembly from transmission case.
- Disconnect the select cable from range select lever, and then remove the cable bracket.
- Remove the select cable from plate assembly.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.